Installing video wall hardware

Once you have planned and collected your hardware, you can set it up. First, install your displays and place your sources. Then connect your displays to your output modules and your sources to your input modules.

Who can do this?

Anyone can do this task, but we recommend that you consult a qualified AV installer.

Placing your CORIOmaster™ and video wall

When you decide where to place your hardware, consider these points:

• Availability of electrical outlets

• Distance from CORIOmaster to sources and video wall

  For best results, use cables under 15 m long, or shorter if you use connection adapters. If you need to place your CORIOmaster more than 15 m away from your video wall or sources, use a signal extender.

  Read about our adapters

  See our range of signal extenders at tvone.com

• Installation environment

  In industrial environments, use shielded Ethernet cables.

Position your displays and sources

1. Use your plan to help you position your displays, which can be screens and/or projectors.

   Make sure you note all the measurements, so you can make an accurate video wall in CORIOgrapher™.

2. Position your sources. Follow the advice above when you choose where to put your sources.

3. Connect your displays or projectors to the output modules of your CORIOmaster.

   

   Keep a note of which display is connected to which port. You can use this information later when you name inputs and outputs in CORIOgrapher. You can also label the inputs and outputs directly.

4. Connect your sources to the input modules of your CORIOmaster.

   

   Keep a note of which source is connected to which port. You can use this information later when you name inputs and outputs in CORIOgrapher.

5. Connect your CORIOmaster to your network. If you want to control your CORIOmaster with a serial controller, connect a serial controller.

   

6. Connect your CORIOmaster to an electrical outlet and power on.

   

You can now create your video wall in CORIOgrapher.